I had been using a poor quality SD card for some time after first activating it.
Today, I received a high quality SD card and replaced it, but when I took the card out, I did not do anything to remove it.
From that moment on, the main screen became Aimation Error! and I could not connect via Bluetooth or USB. Resetting to factory defaults does not change this. How can I get it working again?
1 Like
Probably firmware update, forced (repair) if necessary.
1 Like
Agreed! I believe a firmware flash must always be done after a factory reset. Otherwise the Flipper doesn’t have a region set from what I understand. Additionally Official Firmware should always be flashed first when a Flipper is set up for the first time. That is probably the best practice after a factory reset as well.
Regular update
Recovery