Model: Boss
Garage.sub (90.4 KB)
Model: 2211-L
FCC ID: N6U303KTX
1 Like
your key fob operates at a frequency of 303 MHz. add this frequency to subghz\assets\setting_user
Frequency: 303000000
and try recording and playing back the raw signal near your gate. if everything goes well, let me know, we will add your system
With or without the # in front?
And after adding that should I have a 303 option in read raw config?
I get a transmission is blocked on this region error
may be blocked. But you must accept. record RAW file with 10+ button presses with 3+sec delay
I’ll grab the file in the morning for you.
Hey I finally got the captured on 303 frequency
One of them is button clicks & the other is short holds of the button
Presses:
303.sub (169.7 KB)
Hold:
Boss_garage.sub (206.5 KB)
Hey @Neokilla I think those recordings aren’t good. As I also have picked up two of these garage remotes and am looking into the protocol. You needed to hold the remote directly underneath the flipper in the middle. As it’s not rolling codes holding down the button then starting the recording then stopping the recording is the best.
AM650
I can’t seem to upload the recordings I took but with:
Short = 500
Long = 1000
Gap = 1500
Remote with single button
Button 1: DE 46 2C A8
Remote with dual buttons
Button 1: D4 52 9C A8
Button 2: D4 52 9D 28