When I am trying to add my iButton with the actual key I get an error message saying ‘CRC error: This is not a key’. I have tried using another key of the same type and I get the same issue where it complains about the CRC error.
1 Like
Can you provide the ID of the key? It seems like you’re using something different from Dallas/Metakom/Cyfral, and the Flipper doesn’t support those keys yet
I can tell you they key is made by Schlage and it is one of the 1w and 125KHz keys
1 Like
No, I mean the hex ID that the Flipper shows
The flipper is reading 0C A7 EB 4B 00 00 00 02
This error should be non-blocking and you should still be able to save and emulate the key. This error only states that the CRC part is not what it should be on a DS1990 key. Your key is probably one of the other models, so you can just ignore that error.
I have not been able to successfully emulate the key yet. I will keep trying later today and see if I can get it working
This means that the key is not DS1990. We do not officially support emulation for other key types for now
I have to try this when I get the key, but I see that the Schlage ibutton is also a 125Mhz HID. I am thinking of trying to just read and emulate the 125Mhz credential. Schlage IBF-120 Combo 125 kHz Proximity & iButton Fob (25 Pack) | GoKeyless
The problem is that flipper doesn’t know about that format on 1-wire level so it’s expecting a Dallas type of key and it’s not even reading properly the entire lenght/content of your key. We need read raw for 1-wire !
2 Likes