I found some IR command codes online published by the manufacturer for a device however it does not include what ‘protocol’ is used for the infrared (which I see is an attribute in the .ir file that I am editing), and it also does not include the ‘address’ code for each command code. I am assuming the ‘type’ property should be set to ‘parsed’ as these are not raw signals, and I am going to go with the ‘NEC’ protocol but I am very confused with the address attribute. Also, on the manufacturers website they did not include the last 2 digits for some of the signals, should I assume these are just 00?
1 Like
I think you should actually show us an example. What you have is likely incompatible. You also might simply go to one of the Flipper irdb collections because most devices are already there.