Flipper as client or controller

#1

I think I’ve seen it mentioned that flipper can’t act like a USB Controller due to limitations of the hardware. Is that correct? What about if something else was to control the flipper over wifi with the Wifi Module? Could someone in theory setup the ESP32 Wifi module to allow someone to control the SubGhz app through a webpage or MQTT apps on the ESP32?

In theory that’s possible correct? The flipper could be controlled remotely though the wifi module?

#2

If you can setup the communication between the flipper and the devboard then yes, the board can be used to control the flipper via WiFi/USB

#3

Thanks @Astra , I’m assuming it would also be over the same pins debug use? Wi-Fi Debugger Module - Flipper Zero — Documentation