IButton pins fell off

[EpicErik_HD]

Hello, i recently opened my Flipper Zero, but I ripped the IButton pins out. Is there an way to fix them?

[jmr]

1. That is the least useful thing the Flipper does. Do you need that function?
2. If you do need that function see below quote.

@Astra

You can try plugging wires into GPIO pins 17 and 18 and touching wire 17 to the center of the reader, and wire 18 to the edge of it. Some people have made a DIY adapter from a used iButton key by soldering those wires to it from the inside.

You can read more on how iButton works on the Flipper here: Taming iButton Keys with Flipper Zero

Flipper does plan to sell replacement parts at some point. Hopefully Q2 this year. You might also be able to replace them with pogo pins if you find the correct size.

[cnomax]

Perhaps,the best way to do is to switch to a new Pogo pin.
Here is pogo pin factory for your REF.

Below is Cnomax pogo pin Connector Catalogue

2.54mm-Pitch-pogo-pin-connector-Catalogue

1.27mm-Pitch-pogo-pin-connector-Catalogue
2.0mm-Pitch-pogo-pin-connector-Catalogue
2.54mm-Pitch-pogo-pin-connector-Catalogue
Magnetic-Connector-catalogue
USB-Magnetic-Cable-Catalogue
Thread-Pogo-pin-Catalogue
Double-end-Pogo-pin-catalogue
Female-Pin-Catalogue
Right-angle-Pogo-pin-Catalogue
Side-Solder-Pogo-Pin-Connector
Side-Solder-Pogo-Pin
DIP-Pogo-pin-Catalogue
SMT-Pogo-pin-Catalogue