Hello,
This is a great little device, I’m really enjoying it.
I seem to be having an issue with adding new IR signals to a remote. It works just fine for a while, but I am usually able to add 2-4 new signals before the device just stops picking up any IR. I have confirmed this by checking the Debug>IR Monitor and there is no activity even while blasting the device with a remote.
I am not sure what causes the device to start receiving again - I have tried powering off via Settings>Power as well as rebooting but the only thing that seems to work is waiting for a while before trying again.
I did the latest firmware update today after the issue appeared, and that did cause the device to allow me to add a few more signals before it stopped receiving again.
On a side note, this same behavior also happened while I was storing some low frequency RF remote signals. That was a while back though, and I’ve tested it less.