Not supported key

Frequency: 433.92
Nothing in Read

Photos:


Files with key presses:
Down.sub (16.9 KB)
Up.sub (16.6 KB)

1 Like

I have one of those. Nothing I have tried will recognize it but I haven’t actually tried a full blown SDR. What device are you using it to control?

Yes, this protocol can be added, it is static and replaying RAW recording should work. But I see that the records that you provided me are the same, does your remote control have 1 button and up and down? what is the name of the system? or from what this remote control, and it is clear that it is not original, give more records and information on the system and we will add it

The remote looks like a generic universal remote used to learn a signal and replay it. Most likely the signal is a copy of an original remote. At any rate it will be cool to have flipper know this protocol as well.

I was given it at work to control the gate, if you have the same one, then try to record the buttons with a flipper in RAW mode (better 3 clicks on each button for a few seconds), it will probably be easier to study the protocol with more samples

I didn’t get anything from mine last time I tried. I’ll give it another try.

have you tried a frequency analyzer? you recorded raw on 433.92, nothing at all? from all buttons?

I can’t even verify the remote is working accept a red Led. It’s one I bought on Ebay and never used because it did not seem to work. No manual came with it and the only marking says 433. Perhaps it isn’t programmed with a code.

EDIT: After a good deal of messing around I see this remote did not come preprogrammed like other remotes I bought.