Hi, I got this remote power sockets. They were not registered by the reading mode so I thought I contribute the raw files. I will later add a photo of the backside of the remote control.
ch2_off.sub (2.4 KB)
ch3_off.sub (3.2 KB)
ch3_on.sub (1.4 KB)
ch1_off.sub (6.3 KB)
ch1_on.sub (7.9 KB)
ch2_on.sub (3.0 KB)
Does repeat playback of the recorded signal work? something tells me that no, the file size is very small, you either chose the wrong frequency or modulation
Works without an issue.
How would I change frequency or modulation in raw files?
if you recorded RAW at the wrong frequency or modulation, then the changes will no longer help. you need to record immediately on the correct settings
although I may be wrong. it looks like a transmitter signal.
The question is, does the receiver react to it when replaying RAW?
and make a longer recording of button presses. let’s press the button 1 on 10 times while holding the button for 3+ seconds
I do not completely comprehend the problem, but I will record samples of 10 presses when I am home. But at least I can say, the recorded samples do work flawlessly. I will check to make sure to be on the right frequency, but I am not sure what to do about the modulation.
if they work, then I was wrong. but I still need to record several long button presses in order to correctly implement the signal encoder
Thank you so much for your extensive support. i will deliver as soon as work and kid let me!
Hi, es expected always ten presses, some longer some shorter, but al are tested and work. Frequency is 433.92 and modulation AM650, as it worked. But for the modulation I have no hint if it is correct.
Thank you.
Ch1off.sub (57.4 KB)
Ch1on.sub (56.6 KB)
Ch2off.sub (41.6 KB)
Ch2on.sub (35.5 KB)
Ch3off.sub (43.0 KB)
Ch3on.sub (38.3 KB)
interesting protocol. this have not happened before. That’s why I asked to record long keystrokes.
the protocol consists of alternating 2 different messages. first send 6 repeats, then second send 4 repeats and then again first… PPM encoding
@Crinkly0954 did you keep the button pressed for more than 3 seconds? because I see transmission codes but they are very short.
please record 2 buttons (on / off) but keep the button pressed on the remote control for 10 or more seconds. at least 4 clicks each
Will do!