Prastel remotes

Hello, I have a garage door. The brand is SEG , as far as I know it is not distributed in USA. I did a little research and the remote control is very similar to this one

Is possible that the flipper support it ?

I read a thread that I need to capture raw signals but I am not sure the modulation of the remote , should I do the capture in the 4 modulations?

Flipper should support some Prastel with fixed codes already.

Start by placibg flipper in READ mode, set frequency to 433.92 and see if flipper does pick up any code using the 4 available pre-sets. If not be aware that playing with rolling codes might de-sync your original remote, You can try to go to read raw and save a sample using the 4 availabe pre-sets one at a time and away from the reciever. Then use flipper to replay the saved signal near the reciever and see if it does work, if it does you are good to go if not further investigation is required like using a SDR to figure out the correct preset / modulation settings, etc …