Request - IR Add manual

It would be nice when adding a new remote or remote command to have an option to add manual and then select the protocol (example RC5), address and command.

This would be of use for example if you have already read a remote or are using a file and you want to add a specific command that you know about or want to test without editing the file with a notepad outside of the flipper.

It would be a little bit like adding a UID by add manualy instead of editing the flipper file with a tex editor…

1 Like

I manually edit the .ir files and that isn’t too bad but it might be nice sometimes when i just want to make a minor change.

1 Like