Hello, it’s my first post on the Flipper Zero forum so excuse me if I make any mistake.
I was sent here by the Flipper Zero email support team.
The problem I’m having is that every time I add files with my computer to the Flipper Zero when syncing via Bluetooth with my iPhone the app goes into a loop. When I add numerous files it becomes a nightmare to sync.
I think the connection drops when syncing. Then the app reconnects and retries to sync.
Sometimes it reaches 53% and disconnects, sometimes the next time it reaches more, or sometimes the process starts again before reaching the previous percentage. In the end, it ends up synchronizing completely, but with reconnections in which the percentage gradually advances (and for that reason it takes a lot of time in comparison to syncing in one time).
To get an idea, one time it may reach 54%, the next time only 45% and the next time 60%, but it progresses little by little (the following times it will be faster to reach 60% and reach 63% before disconnecting, to give an example. I imagine it reaches 60% faster, in this example, because it has managed to send some information to the phone even if it is not fully synchronized) until it reaches 100%.
As I said it looks like it’s because the app disconnects from the device.
I’ve already tried to unlink the Flipper Zero, forget all Bluetooth devices on the Flipper Zero, reinstall the app completely and start again.
I’m on iOS 16.2
Thank you in advance for your help.