I was trying to add an Elite Entry remote FCC is NIFDT 1000 (the remote to my community gate) and the flipper could not pick it up in read. It is an 418 MHz remote. I was able to pick it up two times out of like the 100 times I clicked. It read a CAME 28 bit with the same codes on both. I don’t know why its so rare to pick it up so maybe its unsupported. I tried very close to the flipper and an arm length away with the same result. (note I am not 100% sure of the modulation but try all of them with the same result.) I picked up the remote in the default modulation. I have attached everything I know about the remote. FCC with pics FCC page Another FCC page
perhaps for further conversation, you may need a RAW recording of at least 10 presses while holding the button for 5+ seconds
ideally, open the remote and record 3 gears with jumping places where there should be 4 buttons. then I can make an accurate display of the pressed button, including
and judging by the “code” number on the back cover, the transmission must be 32 bits
There is some info on the signal.
This applies to version 1 from 1997.
https://fccid.io/NIFDT1000/Attestation-Statements/Duty-Cycle-Info-35627.
GOOD! give real console records at 433.92. AM650
and on 418 … in general, what does the frequency analyzer show
Unfortunately I am not home right now but I will be sure to get this to you sorry for not including it.