Mini ESP32 Wifi Module

3rd-party modules
#14

Ok, thanks, the problem is that WiFi Devboard is soldout, but i will wait that it is available.

Thanks for the support.

1 Like
#15

No problem. Let me know if you manage to make it work later with the dev board. Regards.

#16

Oh yeah it looks like the pins have been switched. I’ve designed a revised version of the board here: OSH Park ~

Changes:

  • Fixed the issue where TX/RX have been flipped
  • Added an LED connected to GPIO4 for ESP32
  • Added an on-off switch to enable/disable the wifi module (to save power)
  • Replaced programming header with a PCB jumper, so that in theory the ESP32 could be flashed using the Flipper USB-UART bridge by pressing something conductive against it while turning on the module
  • Added space for another bypass capacitor for better power stability

It hasn’t come in yet, so I don’t know if it’ll work

As for why the ESP Marauder doesn’t seem to be compatible, this module uses an ESP32-S instead of an ESP32-S2 (which is what the Wifi Dev Board) uses. I suspect that it should be possible to recompile ESP Marauder to work on the ESP32-S.

2 Likes
#17

Thanks for sharing the second version of the project.
Is it possible to draw the PCB for ESP32-S2 WROVER?
This should be exactly the chip installed on the original development board.
By doing this we should minimize the incompatibility problems.

#18

Here’s a variant that uses the ESP32-S2 WROVER OSH Park ~

1 Like
#19

Thanks antimatter15 !

#20

Hi, I tested the ESP32-S with the Marauder Firmware and work fine, i bought the pcb fixed. Thanks for all .

20221015_005533
20221015_0055334032×3024 2.98 MB

1 Like
#21

New version of the circuit board seems to work (using Marauder Mini firmware rather than the Flipper version)! My PR for adding pins 16/15 as DTR/RTS pins was landed recently which should make flashing/reprogramming much easier.

image
image1398×1144 94.6 KB

4 Likes
#22

I love the design and I’d like to create one myself.
besides the board and ESP-S2-module, what other parts do I need for this?

#23

Hey mate, looks awesome, is there any BOM list? I see in the bottom side some footprints c1 c3 R1 LED1, looks like a led, resistor, and… but le me knwo what we need :slight_smile:

Thanks and congrats by the initiative.

2 Likes
#24
  • D1: 2V LED
  • R1: 68 R
  • C1: 0.1 uF
  • C2: 10 uF

Probably :slight_smile:

3 Likes
#25

awesome thanks!

#26

According to another schema:
https://github.com/DrB0rk/Flipper-Zero-Boards/tree/main/Multi%20boards/Multi%20Board

1 Like
#27

Can you send me the products link of the working version, i would like to buy the components thx.

2 Likes
#28

Hello my friend, could you send me the links of what you used tu build the working esp 32, thx

1 Like
#29

Any update on this? Would love a parts list as well.

2 Likes
#30

Any chance you had a part number for the switch on the S2 version? I believe I have found everything else I need on Mouser, but I don’t think I can find a switch small enough.

Thankyou for your time.

#31

Hey can we all have a parts list please. TY!

#32

This is the switch you need. You’re welcome.

1 Like
#33

This is super cool!!!